Your software provides you with more than just buy/sell signals. And the next few minutes you will learn how to use it for maximum results.
The most important part of this area, is the signals section. When there is no signal at the moment, this area would be empty.
But if there is a current signal, entry point, stop loss point and take profit point would be given to you in this section. All you need to do is to copy/paste these information to your trading platform.
Also note that when there is a new signal, you would get an alarm window with the same information ( entry – stop – target ).
This version of the software works best for scalping and intraday trading. You can use it with all major pairs but you must use it only with these time frames: 5M – 15M – 30M and 1H.
Once you attach the indicator to any chart for any pair, go through all the above time frames until you get a signal. Once there is a signal you should get an alarm window then confirmation data ( signals details ) would show up in both area A and B, as explained.
If you get two signals, for two different time frames for the same pair..you can open two separated trades for each signal or choose the higher time frame.
After opening the trade, the signal may disappear, that doesn’t mean the signal is not valid anymore. You can keep the trade open until it hits target or stop loss.
You can use this software anytime, but it’s highly recommended that avoid major news releases. Best time would be when the market is quite. Example, for scalping the Asian session.
If there are no signals at the moment for any pair, simply choose a different pair. if you still not getting any signals ( very rare ! ) then wait few minutes and check again.